(+65) 6284 3818


250°C 200mm Width Hot Rolling Press with 10 mm Adjustable Gap - MSK-HRP-05

250°C 200mm Width Hot Rolling Press with 10 mm Adjustable Gap - MSK-HRP-05

0.0/5 rating (0 votes)


MSK-HRP-05 is a 200 mm width Heated Rolling Press with Max. 10 mm rolling gap and Max. 250℃ working temperature, which is designed for preparing the polymer composite materials.  ( Gap is increased to 10 mm since  Jan 15, 2022 )











Effective Rolling Width

200 mm

Roller Material  &  Size
  • High strength hardening steel with hardness with RC > 52 
  • The Roller surface is plated by Cr for anti-corrosive
  • Size: 96 mm Dia. x 220mm W

Roller Gap

  • 0~ 10 mm adjustable
  • Note: The gap tolerance may vary with temperature raising as below
    • RT - 100°C: 0.008 - 0.01 mm
    • 100 - 150°C: 0.02 - 0.03 mm
    • 150 - 250°C: 0.03 - 0.05 mm

Dial Gauge Accuracy

Rolling Thickness &
  • Min. 0.01 mm
  • Max. 10.0 mm
  • Max. the hardness of sample to be rolled:  < 40 HRC
Heating Temperature

  • Two digital temperature controllers with 30 segments programmable for control two rollers separately
  • 250°C maximum ( <= 1 hrs suggested)
  • Recommended Heating Rate: 1.3°C/minute
  • Two heating elements are installed
  • Power of each Heating Element:  1000W
  • Temperature Control Accuracy: +/-5°C
  • Two spare heating rods are included for replacement. Pls click pic left to see specs.



  • High torque motor with reducing gear, which can run under Ar gas safely
  • Rated power 100W
  • Digital speed  Display: 0~26 mm/s
  • Digital controlled with constant output power 
  • For Roll to Roll, please consider below R2R device (click picture 1 & video to order)
  • We can modify the rolling press into a vertical position at the extra cost (Pic. 4)
   Pic. 1  Pic. 2  Pic. 3
  • 620mm(L) x 280mm(W) x 400mm(H)
  • Shipping Dimensions: 40" x 30" x 25" (D x W x H)



Shipping Weight

280 lb

Compliance & Warranty
  • CE Certified
  • MET certificate is available upon request at extra cost.
  • One year limited warranty with lifetime support
  • Rusting and damage due to improper storage conditions or maintenance are not covered by a warranty
Demonstration Video
  • Do not touch the surface of the rolling part of the machine when the rollers are heated up or running.
  • Due to the influence of working environments, the temperature on the roller surface may be different from the display on the controller. You may calibrate the temperature by EQ-TC-calibrator-LD, and refer to the instruction here from time to time to ensure heating temperature accuracy
  • Multi-step thickness calendering needed: While calendering the sample sheet, make each calendering decrement of 0.02mm compared with the sheet's original thickness.
  • Never calendering decrement over 0.02mm compared with original sheet thickness each calendering.
  • Never roll materials with hardness > 40HRC
  • Clean roller surface after each use and lubricate rollers when not used to avoid corrosion
  • It is not allowed to use any MTI product in Class I environments (flammable gasses & vapor).

Share this product

Register for new product information:    

Premier Solutions (PS) Pte Ltd Singapore

Please publish modules in offcanvas position.