Phone

(+65) 6284 3818

Email

sales@premier-sols.com

Enquriy
4-channel potentiostat model CS3104 (EIS*1)

4-channel potentiostat model CS3104 (EIS*1)

0.0/5 rating (0 votes)

Description

Product Introduction
CS3104 multichannel Potentiostat Galvanostat can achieve simultaneous measurements for up to 4 channels. For each channel, current control range is ±500mA, potential control range is ±10V. It supports floating mode, and uses Ethernet connection. Each channel is completely independent. Multichannel potentiostat brings convenience to those who have many samples, and is an ideal device for studies of energy materials, metal corrosion etc. EIS module (10μHz~1MHz) is equipped one channel.
 
 
Applications
(1) Reaction mechanism of Electrosynthesis, electrodeposition (electroplating), anodic oxidation, etc.
(2) Electrochemical analysis and sensor; 
(3) New energy materials, advanced functional materials, photoelectronic materials;
(4) Corrosion study of metals in water, concrete and soil etc;
(5) Fast evaluation of corrosion inhibitor, water stabilizer, coating and cathodic protection efficiency. Standard supply
Instrument host *1
CS studio software package *1
Power cable * 1,
Ethernet cable *1
Cell cable *8
Dummy cell *4 After-sales Service (All the service is totally FREE)
1. Warranty period: 5 years.
2. Provide manual, software installation video & training videos.
3. Free repair service
4. Lifetime software upgrading (same model) and technical service.
Simultaneous Measurements In each channel, the customer can conduct experiment at the same time. As is shown in the below picture, EIS, galvanostatic charge and discharge, CV, and polarization curve tests are conducted at the same time.
''
Specifications
Specifications
Number of channels: 4 Channel insulation resistance: >100MΩ
Communication: Ethernet Lower-pass filter: covering 8-decade
Potential control range: ±10V Constant current control range: ±500mA
Potential accuracy: 0.1%×full range±1mV Current accuracy: 0.1%×full range
Potential resolution:
10μV(>100Hz), 3μV(<10Hz)
Current resolution: 1pA
Potential rise time: 1μs(<10mA),<10μs(<2A) Current range: 2nA ~500mA
Reference electrode input impedance: 1012Ω||20pF Maximum current output: 500mA
Compliance: ±12V Current increment during scan: 1mA @1A/ms
CV and LSV scan rate: 0.001mV~10000V/s Potential increment during scan: 0.076mV@1V/ms>
CA and CC pulse width: 0.0001~65000s DPV and NPV pulse width: 0.0001~1000s
SWV frequency:0.001~100KHz CV minimum potential increment: 0.075mV
AD data acquisition: 16bit@1MHz,20bit @1kHz IMP frequency:10μHz~1MHz
DA resolution:16bit, setup time:1μs Current and potential range: automatic
Operating System requirements: 
Windows 7/win8/win10/11
Weight: 12Kg       
Electrochemical Impedance Spectroscopy(EIS)
Signal generator
Frequency range:10μHz~1MHz AC signal amplitude: 1mV~2500mV
Frequency accuracy:0.005% Signal resolution: 0.1mV RMS
DDS output impedance: 50Ω DC Bias: -10V~+10V
Wave distortion: <1% Waveform: sine wave, triangular wave, square wave
Scan mode: Logarithmic/linear, increase/decrease
Signal analyzer
Maximum integral time:106 cycles or 105s Measurement delay:0~105S
Minimum integral time:10ms or the longest time of a cycle
DC offset compensation
Potential compensation range: -10V~+10V Current compensation range: -1A~+1A
Bandwidth adjustment: automatic and manual, 8-decade frequency range
 
 
Techniques
Techniques – CS3104 (One of the channels includes EIS)
Stable polarization
  • Open Circuit Potential (OCP)
  • Potentiostatic (I-T curve)
  • Galvanostatic
  • Potentiodynamic (Tafel plot)
  • Galvanodynamic (DGP)
Transient Polarization
  • Multi Potential Steps
  • Multi Current Steps
  • Potential Stair-Step (VSTEP)
  • Galvanic Stair-Step (ISTEP)
Chrono Method
  • Chronopotentiometry (CP)
  • Chronoamperametry (CA)
  • Chronocaulometry (CC)
Voltammetry
  • Linear Sweep Voltammetry (LSV)
  • Cylic Voltammetry (CV)
  • Staircase Voltammetry (SCV)
  • Square Wave Voltammetry (SWV)
  • Differential Pulse Voltammetry (DPV)
  • Normal Pulse Voltammetry (NPV)
  • Differential Normal Pulse Voltammetry (DNPV)
  • AC Voltammetry (ACV)
  • 2nd harmonic AC Voltammetry (SHACV)
  • Fourier Transform AC Voltammetry (FTACV)
Stripping Voltammetry
  • Linear Stripping
  • Staircase Stripping
  • Square Wave Stripping
  • Differential Pulse Voltammetry Stripping
  • Normal Pulse Voltammetry Stripping
  • Differential Normal Pulse Voltammetry Stripping
Amperometric
  • Differential Pulse Amperometry (DPA)
  • Double Differential Pulse Amperometry (DDPA)
  • Triple Pulse Amperometry (TPA)
  • Integrated Pulse Amperometric Detection (IPAD)
 Electrochemical Impedance Spectroscopy (EIS)
  • EIS vs Frequency (IMP)
  • EIS vs Time (IMPT)
  • EIS vs Potential (IMPE)(Mott-Schottky)
Corrosion Measurements
  • Cyclic polarization curve (CPP)
  • Linear polarization curve (LPR)
  • Electrochemical Potentiokinetic Reactivation (EPR)
  • Electrochemical Noise (EN)
  • Zero resistance Ammeter (ZRA)
Battery test
  • Battery Charge and Discharge
  • Galvanostatic Charge and Discharge (GCD)
  • Potentiostatic Charging and Discharging(PCD)
  • Potentiostatic Intermittent Titration Technique (PITT)
  • Galvanostatic Intermittent Titration Technique (GITT)
Extensions
  • Electrochemical Stripping/ Deposition
  • Bulk Eletrolysis with Coulometry (BE)
  • Rs Measurement

Share this product

Register for new product information:    

Premier Solutions (PS) Pte Ltd Singapore

Please publish modules in offcanvas position.