(+65) 6284 3818



Compact Levitation Cold Crucible Vacuum Melting Furnace(10KW, 5g Max.) - EQ-FMF-10

0.0/5 rating (0 votes)


EQ-FMF-10 is a compact Vacuum Float-Melting System for exploring new generation magnetic alloy and metallic materials. The system uses a 10KW high-frequency induction heater to make metallic sample ( 5g max) melting by magnetic vortex within a special designed water-cold copper crucible placed inside a vacuum-sealed quartz tube. Therefore, it can produce extra high purity metallic alloy without any contamination.
Induction Heater
  • Working Voltage: 220VAC  three phases)   50/ 60 Hz. 
  • Working Current: 5-25 Amp (30A breaker required)
  • Output Frequency: 50-300 kHz Adjustable
  • Max. Output Power: 10KW
  • Required Water Flowrate: >16 L/min
  • Two Unit: the Power control unit is separated with the induction heating unit
Copper Crucible
  • Dimensions: 27 mm(OD) x 10 mm(ID) x 12 mm depth
  • Water cooling inside
  • Required Water Flowrate: >40 L/min
  • Max. Load:  5 g for  metallic or alloy
  • Required water: > 40 L/min.
Recirculating Water Chiller
and  Gas required
  • If you don't have water cooling line, please consider our recirculating water chiller 58L/min at extra cost.
  • High purity Argon gas ( > 5N) tank with pressure regulator is required, but not included. Click here to learn more about the installation of a gas regulator. ( please click the picture below right to order a correct gas regulator )
  " alt="" width="98" height="65" style="border: 0px;" title="Click to enlarge" />    
Quartz Tube & Vacuum Flange
  • One quartz tube included: 32 mm(OD) x 28 mm(ID) x 160 mm(L
  • One pair of Vacuum Flanges with double high-temperature silicone O-rings
  • Max. Vacuum Pressure:
  • Bottom flange is controlled by an electric motor for easy sample loading and unloading
Vacuum Pump
  • One two-stage mechanical pump with exhaust filter is included
  • KF25 adapter, bellow, and valve are included for immediate use
  • The vacuum pump is integrated into the movable steel case
  •                    .
Product Dimensions 450 mm(L) x 950 mm(W) x 1485 mm(H)
Warranty One Year limited warranty with lifetime support
Application Notes
  • The Melting System are designed for using under vacuum and low pressure < 0.02 MPa / 0.2 Bar/ 3 PSI 
  • Attention: A pressure regulator must be installed on your input gas tank  and have the output gas pressure set below 3 PSI  with the gas maintained in a continuous flowing condition. Gas build-up with pressure levels exceeding over 3 PSI may cause irreversible damage to the furnace chamber.  
  • Never heat the furnace while the gas release valve is closed and a positive pressure condition exists within the furnace chamber. 
  • The flow rate for gases should be limited to < 200 SCCM ( or 200ml/min )
  •  WARNING  
    Read the manual carefully. Monitor and control the inside pressure of the reaction vessel at all time during operation. Otherwise, failure of operation may result in irreparable damage.
Compliance        NRTL or CSA Certification is available upon request  at extra cost
Operation Manual & Video                 
Net Weight 120 kg

Share this product

Register for new product information:    

Premier Solutions (PS) Pte Ltd Singapore

Please publish modules in offcanvas position.