Compact Precision Disc Cutter with 4 Sets of Cutting Die (15, 19, 20 & 24 mm) - MSK-T-07

Four sets of cutting die: 15, 19, 20 and 24 mm diameter are included in the standard package:

• 15mm (for electrode discs of CR20xx series coin cell cases)
• 19mm (for electrode discs of CR20xx series coin cell cases and CR2325 negative side cases)
• 20mm (for electrode discs of CR2450 cell cases, CR2325 positive side cases, and separator discs of CR20xx series coin cell cases)
• 24mm (for electrode and separator discs of CR24xx series)
• Note: By using 24mm and 15mm die，can prepare 15mm ID x 24mm OD O-ring as reference ring for three-electrode split test cell  ( The special die can be ordered in the options bar at extra cost)

• With handle: 140mm(L) x 220mm(W) x 338mm(H)
• Without handle: 140mm(L) x 220mm(W) x 150mm(H)

                                            

• One-year limited manufacturer warranty with lifetime support
• Rusted and damaged parts due to improper storage condition or maintenance are not covered by warranty

• If you are going to make CR2016, CR2025 or/and CR2032 coin cell batteries, you will need at least three cutting dies:
  • 15mm (for negative side case, which is 16.5mm in diameter)
  • 19mm (for positive side case, which is 20mm in diameter)
  • 20 mm (for the separator to fully separate the electrodes in both negative and positive cases)
• In order to cut thin separator,  please cut it together with an A4 paper for a better result
• For CR2450 coin cells, a 20mm cutting die can be used for cutting electrode discs and the 24mm cutting die can be used for cutting either electrode discs or separator discs
• Separator discs must be large enough to fully separate the positive and negative electrodes to avoid short-circuit inside the coin cells
• Warning: You must pay great attention to die change from one size to another. Misalignment will result in die damage. Please read the operation manual carefully when changing die.  MTI is not responsible for the damage caused by misoperation.  Strongly suggest buying several cutters with pre-installed die sets.