Customized Splittable Dry Pressing Die for Ring Type Sample - Die-Ring-C

Die-Ring-C is a customized drying pressing die for making annular samples.

SPECIFICATIONS:

Dimension of die	ID:    20 - 35mm ( +/- 0.01 mm ) OD:   40 - 70mm Height:   25 - 50 mm The customer must provide the drawing of the ring-type sample with tolerance for quotation
Materials	Cr12MoV Hardness: HRC 60
Max. Load	350 MPa
Pressing die installation schematic
Instruction
Application Notes	To get the better density of samples, please considering using a cold isostatic press (CIP) Small particles may slip into the gap between the pushing rod and steel sleeve and cause damages to the sleeve during the compression. We recommend using 32~75 microns powder to avoid damages. Please consider using the 3'' Dia. Sieve Set No.200&450 Mesh to get 32~75 microns particles   Please use alcohol to clean the pressing die every time before and after use Store it in a dry place with antirust oil after the operation to avoid rusting. For pressing sticky metal powders such as Al, Mg, Zn, it is necessary to use dry or alcohol-based lubricant to lubricate the die and sleeve set to reduce friction during the compression.  Please must always wear protective goggles during the operation !!!
Warranty	Pressing Dies are consumable products and are not covered by MTI's warranty.