(+65) 6284 3818



Heating Jacket (200C Max.) and Temperature Controller Series for Dry Pressing Dies- EQ-HC

0.0/5 rating (0 votes)



Product structures EQ-HC-45: Heating Jacket I.D is 120mm and suitable for MTI 3" ID Dry Pressing Dies with sleeve O.D 120mm or less. 
  • EQ-Die-75D ( click part number to order)
  • or any other brand dies with dimensions: Outside diameter <120 mm (If die sleeve O.D is less than 120mm, please wrap the die sleeve with copper/aluminum foil to ensure a solid metal contact between the heating jacket and die sleeve)
Jacket Height 50 mm
Voltage  AC 220V 50/60Hz
Working Temperature Range RT - 200 ºC
Thermocouple Type-K
Temp. control method Programmable PID temperature controller
Application Note            
Operation Instructions   
  • Please use alcohol to clean the pressing die every time before use and store it in a dry place with anti-rust oil after an operation to avoid rusting on the surface, because all pressing dies are made by high-stretched carbon steel for achieving high hardness to meet the essential requirements of making ceramic or metal samples. Otherwise, the pressing surface could probably get scratched.
  • To avoid damaging the die core and sleeve, we strongly recommend you use professional laboratory hydraulic presses which ensure the most even pressing interface and uniform pressure force.
  • For pressing sticky metal powders such as Al, Mg, Zn, it is necessary to use a dry or alcohol-based lubricant to lubricate the die and sleeve set to reduce friction during the compression.
  • Do not press flammable, explosive materials.

Share this product

Register for new product information:    

Premier Solutions (PS) Pte Ltd Singapore

Please publish modules in offcanvas position.