Lithium Chip 16 Dia x 0.6/1.0 thick mm for Li-ion Battery R&D 300pcs / bottle - EQ-Lib-LiC-300

Lithium chip is widely used for Li-ion and Li metal rechargeable battery R&D, Please click the link below to see a paper published in Nature Communication" which use MTI metal foil:     
High rate and stable cycling of lithium metal anode
by Jiangfeng Qian, Wesley A. Henderson, Wu Xu, Priyanka Bhattacharya, Mark Engelhard, Oleg Borodin & Ji-Guang Zhang

Purity	99.9% Lithium
Melting Point	180.5 °C
Density	0.534 g/cm3
Color	Silver
Dimension	16 mm x 0.6 mm (diameter x thickness) 16 mm x 1.0 mm (diameter x thickness) Please select the thickness from the product options
Net Weight	20g/bottle (around 300 pcs/ bottle)
Sealing	Chip sealed in Al can which is vacuum-sealed in Al bag
Use	Clean the surface of the lithium foil using a nylon brush/stainless steel scalpel until a shiny silvery surface appears (inside an argon glovebox).
Shipping Limitations	Shipments of lithium foil are described as “UN 1415, Lithium, 4.3, PG I".  All shipments are Hazard Class 4.3 and require “Dangerous when wet” labels. Sea Class 4.3 (IMDG) Road, Rail Class 4.3 11a (RID/ADR)
Safety Data Sheet
Operation	The package must be open inside a glove box with Argon Gas and moisture less than 2%RH.
Notes	MTI only sells Li chips within the USA and does not accept international orders due to restrictions on hazard material  MTI reserves the right to charge an additional handling fee due to special shipping/handling requirements. Operation and Storage: Lithium is very active in the air, please carefully read the SDS carefully. Lithium chips may be oxidized during handling and storage.  if you find any oxidation on the surface of the Li-chip,  please use sandpaper to remove it before using it. The lithium chips were packed in the dry room with < 2%RH. Therefore, a slight increase of O2 PPM level might be seen in the glove box when the can is opened. Please keep purging the glove box with ultra-high purity Ar until the required O2 PPM level is reached.